WALLMOUNT
HERO-SERIES

Locate your HERO charging device easily and flexibly on any wall. The charging cradle is mounted on the wall mount using the screws provided. The cable for the power supply can be conveniently led out from the side or bottom.
Note: On request, the wall mount is supplied with 3M adhesive pads and allows a drill-free installation.
Note: Screws for the wall are not supplied due to the wide selection.

• 
  charging devices of the HERO-SERIES
• 
  production in 3d-printer

NEOPRENCOVER HL-1000-EX

The cover made of neoprene has been manufactured exactly for the HL-1000-EX and can be easily pulled over and off the hand lamp. The cover is easy to clean and simplifies the cleaning and maintenance of the hand lamp itself. Protected from scratches and dirt, the cover also offers a cushioning function in case of falls.

Soon available in the shop

• 
  HL-1000-EX

HERO FRONTCLIP

The additional front clip can be mounted on the front of our HERO-SERIES emergency luminaire. By this the lamp is additionally secured when plugged into breast pockets and holsters and prevents it from slipping out in use – even upside down.

• 
  HERO-SERIES

HERO SNAP HOOK

The snap hook can be attached exactly to the Smart Clip (back) of the HERO-SERIES and thus allows the lamp to be hung on equipment such as breathing apparatus. Due to the ingenious weight distribution, the lamp swings along with the operation and shines almost at a 90° angle to the front. Twisting is largely prevented by the Smart Clip.

• 
  HERO-SERIES / RUGGED CLIP FOR 8890

8890 WALL MOUNT

The wall mount for the 8890 hand lamp can be purchased as an optional accessory. The wall mount can be screwed into place using the holes in the back and bottom of the wall mount. It is supplied with 3M adhesive pads on the back and also allows non-destructive mounting on almost all surfaces. When the 8890 hand lamp is plugged in, two spring-loaded steel balls inside the wall bracket lock the lamp in place precisely. The wall mount is manufactured using an additive fabrication process in a 3D printer using an environmentally friendly plastic (PLA).

• 
  8890
• 
  production in 3D-printer

8800 HELEMT MOUNT

The adapter allows you to adapt the 8800 hand lamp to the MSA Gallet fire helmet.

• 
  8800
• 
  MSA Gallet fire helmet

RUGGED CLIP for 8800/8810

The matching clamp for our hand lamps 8800 and 8810. The clamp can be slid on without tools and secures the lamp in the bag or on the equipment.

• 
  8800 / 8810

RUGGED CLIP for 8890

The suitable extension for our hand lamp 8890. The clip can be screwed on the back, replaces the factory metal clip, and secures the lamp firmly in the bag or on the equipment. With the help of the clip, the lamp can also be adapted to the equipment, e.g. breathing apparatus, by means of a snap hook.

• 
  8890